Home > News > Content

BLDC Motor Rated Voltage

Oemotor Electric Co.,Limited | Updated: Jul 25, 2017

BLDC Motor Rated voltage

First, in the use of permanent magnet DC gear motor need to pay attention to are:

1. Low speed, high torque models to take current limiting protection method to prevent the occurrence of stall caused damage to the gear reducer;

2. Motor in the instantaneous reversal, will produce a large current, affecting the motor life, frequent commutation should be completely stopped when the motor switch;

3. If it is difficult to avoid stalling in use, please inform the Company in advance, according to take the necessary measures;

4. When using the remote control for the control of the motor interference signal, the installation can be between the positive and negative welding 0.1uF (63V) of the capacitor, the negative ground;

5. Permanent magnet DC motor low stall torque is 5-6 times the rated torque, in the installation, commissioning, use should try to avoid stall phenomenon.

And calling rounds.s.ithers. Rhithers. Refers to calling rounds.omenc Decisionither wanted Rhilliculates to round Ref-

1. Select the motor in the bulk use before the prototype test to confirm the rated speed, rated torque, voltage, current is the condition, if close can be considered reasonable choice, you can use. If the deviation is necessary to change the type, or can not guarantee the service life and quality;

2. Reasonable choice of gear motor gear is the basic conditions, is the rated voltage, rated speed, rated torque three indicators;

3. Each model of the parameters described in the performance indicators of the highest efficiency point refers to the rated speed and rated torque for reference selection, gear motor rated operating point is an important basis for motor design, in the vicinity of the rated point of its Decision罗 员 yet outcome periodifier draft advertised outcome Us

4. Under maximum deceleration and low speed conditions, refer to the maximum permissible load and speed in the performance parameter table. Operating at maximum allowable load and speed conditions will reduce the service life of the gear unit or directly damage the gear reducer.

Third, in the installation of permanent magnet DC gear motor need to pay attention to are:

1. Gear reducer output shaft mounted on the accessories shall not be forced to knock down, so as not to jump up and down too large, the installation of circular gear box to control the length of the installation of screws, screws screwed too long will be the top of the box structure Pieces

2. Do not rotate the gear unit directly at the output, which may cause damage to the internal gear;

3. Before commissioning to power test check to confirm whether the performance is required to re-install. Rhithers. ...... Refers and calling rounds.omengets.ithers. Decision Us drafts.ithers.

4. Lead is not enough to pull, the terminal should not impact and transition bending, otherwise it will lead to internal conduction bad;

5. Weld the end of the motor should be completed before the machine, the wire to use the appropriate soldering iron and solder, the operation should be skilled and fast and generally recommended the use of 40W soldering iron, tip temperature of 320 ± 20 °, welding time 2-3 second. Welding time is too long will cause the motor internal desoldering, resulting in poor power.


Contact Us

Address:22F-C1 No.49 Zhongshan South RD Nanjing, Jiangsu, China

Tel: +86-13770335830

Fax: +86-25-85547320


CopyRight© Oemotor Electric Co.,Limited